Functioning rotor blades (9 and 10) are separated sufficiently to get a set up of tyre to become single wrapped. The content is then put on lower edge (10) and upper edge (9) is decreased until it presses to the set up of articles. Both rotor blades will be locked in place on the tire wrapping machine. Materials are then withdrawn by hand from roll (7) making to interact using the set up.

The programmer (15) will be given with data to allow it to look for the frequency and magnitude of reciprocations needed to become carried out through the film roll holder , the rate or rotation from the wheel (5) and the quantity of stopping to be relevant to film carriage/holder (4) in order to make sure that throughout operation from the machine sufficient drag is enforced around the material to make sure about 50% necking even though the extent of necking of tyre wrapping machine will probably vary along with other wrapping materials. On switching around the machine company wheel (5) rotates within an anticlockwise direction transporting by using it the roll of film (7), which using the supporting film carriage/holder reciprocates at right angles towards the wheel (5) on the tyre packing machine.