to the other end on this position lever is hooked up a rod 30 leading to’and-attached to another hand handle, which can be indicated through the nu’meral31, and which happens to be locatedbeside the hand handle 14 within the cab 15. The handle 31 constituting implies where the beam. and

the blades carriedthereby can be raised and lowered. The purpose of the cutting blades is to out to the snowfall and release a similar, and thus disintegrating any clods of snow which might be provide with the road. Your third device in the machine comprises shafts-32 every one of which happens to be fitted atone endin one of many beams 7 and at its other end within the particular runner 1 mounted with each of theseshafts are rims 33′, these rims simply being ideally six in amount in each range, andyprovided with wheels or auto tires 34, these tires serving to level and fairly pack the snow that has been loosened through the rotor blades.

I The fourth device of the machine can be a snow ing curved frontward stop servings 40 are se curedat their forward finishes to the forward one more in a collection located midway in between the joggers 1. A body weight 42 is organized with top of the sidegofthe program 35 and acts 39 .to cause them to go through the snowfall.

“AL linking rod 43 is hooked up at-its lower end to the foundation 35 near to the back aspect substantially and thereof midway between the stops from the program, and it is attached at its higher end to 1 arm 4140f an angle lever,.another left arm 45 of thesaid handle, which leveris attached .uponthebeam 16 on the rear finish thereof, having hooked up toit a linking rod 46 which runs forwardly which is attached to a palm handle 47 positioned inside the cab 15 besidethe handle 41.

The fifth unit in the plow can be a rutv forming system which follows the very last part of themachineand this device makes up an oblong rectangle-shaped mind 48 for the less than area of which are protected two reasonably spaced boots 49 which are made of wooden and that happen to be of substantiallyflwedge creation and which aspects of each sneaker and increasing around the pointedxend thereof. The head 48 is COI1 nected by stores 51 together with the rear finishes of the athletes 1, and inorder that this system could be heightened or tilted, a dish 52′is protected with the upperside of the mind 48 midway in between the stops thereof as well as a linking website link 53 is hinged at its budget to the forward stop in the plate, which is attached at its uppr end to just one left arm 55 of. an angleflever, one other left arm of the angle lever, mentioned from the numeral 56,.experiencing attached to it the back end of your ‘connecting’rod 57*which runs forwardly and it is associated with a’lever 58 positioned inside the cab15 beside the lever 47, the position lever 56 getting fitted for rocking movements on an upright 49 installed with the back cross beam 4. The shoes 49 are spaced separate the identical length as the wheels of an auto and-serve toidisplace the snowtin the ruts which has been; established with the cutting blades 25, rims 33, and also the : rotor blades ’39.