The energy product discloses a whole-automatic remote device upender which consists of a down ramp (1), an aura tube (2), a moving rail (3) and an upender system. The lower ramp (1) is organized about the area face of your moving rail (3). The air cylinder (2) is established at 1 conclusion in the sliding rail (3). A solenoid device (9) is set up at the place of an air flow inlet (10) from the lower area of the oxygen tube (2). The air cylinder (2) is associated with the sliding rail (3) inside a transmission setting. The upender physique is established with the other end from the slipping rail (3). The upender body is supplied having a help (11). A rotary disk (4) which could turn is established in the support (11). The rotary disk (4) is connected with a controller. An overturning shaft (5) is connected about the rotary drive (4). An induction threaded rod (8) is established in the edge of the rotary drive (4). An approach switch I (6) is arranged on one area of the rotary hard drive (4). An strategy change I (7) is arranged in the center of the rotary disk (4).

CLAIMS(2) interpreted from Asian

A method of automatic handheld control switching upender machines, described for the reason that it includes a cheaper ramp (I), cylinder (2), push (3) and transforming upender machine primary body, said rail (3) of a part surface area the ramp (I), the rail (3) aspect of a tube (2), the tube (2) in the decrease part of the inlet (10) in a solenoid control device (9), the tube (2) and rail (3) to the drive connection, the rail (3) with all the opposite end of the switching upender machine system, explained physique is provided with turn bracket (11), the bracket (11) is provided having a rotatable spinning plate (4 ), the rotary plate (4) is associated with a control, the rotating plate (4) is attached to the tilt shaft (5), the rotary dish (4) around the fringe of a sensor attach (8), the spinning disc (4 ) on a single part of your distance change I (6), the rotary dish (4) carries a distance move at the center II (7), when the rotary dish (4) for sensing the attach (8) check out the distance switch I (6) , the indicator screw (8) as well as the nearness change I (6) corresponds, once the rotary dish (4) for sensing the attach (8) proceed to the proximity move II (7), the sensor attach (8) along with the proximity change 11 (7 ) matches the proximity swap 1 (6) along with the distance change II (7) and solenoid control device (9) related for the interconnection, wheel from the after that ramp (I) roll for the rail (3), the control handles the turning drive (4) rotation, once the revolving dish (4) for sensing the screw (8) visit the distance move I (6), the nearness swap I (6) starts the solenoid valve (9), the solenoid device (9) is full of energy to look at the tube (2) Air intake, tube (2) to start the petrol tube (2) to advertise rail (3) will probably be forced towards the spool shaft Change (5) above, the revolving platter (4) by turning the shaft ( 5) pushed spool rotates when rotating disc (4) rotated by 90 ??, closeness switch II (7) shuts the solenoid control device (9), shut off gas, rail (3) immediately returns to the original position.

(2) as claimed in state 1, whereby the handheld control of automatic turning, recognized because mentioned proximity switch I (6) along with the rotary disc (4) in accordance with the midst of one side from the nearness swap II (7) and turning platter (4) related to the positioning of the bottom part, the rotary disc (4) check out the proximity move I (?¤ 6) if the rotary disc (4) go to the nearness swap II (7) in the angle big difference of 90 degree.